Still no go on the kit 2, anyone else put this kit together in the last year?

Still no luck with the paper weight I purchased 3 months ago. I have had better luck rebuilding the dynaco 70's along with a hagerman preamp.
closest has been music from the 6SN7's. I replaced the heater resisters for the 6550's.
No go, I had to buy another set of sockets for the 6550's aswell and get the board that is holding the 6550 sockets in place up off of the frame. I have the violet wire running to the .68 ohm resister, other end connected to pin 2 and a wire going from pin 2 of same socket to another .68 resister and the other end of that resister connected to pin 7. I have two grounds from pin 2 and pin 7 (aposit) feeding back to ground with the green/yellow wire.

I bought new eh 6550 not knowing if I screwed the old ones up or not.

If anyone has pictures of where the blue/white should be connected to the power supply board, The orange/white, brown/white should be as well. Right now I have the Blue/white and the orange/white connected to W13 of the power supply board. I have the Brown/white connected to ground on the power supply board.

These are the center tap for the 6SN7's and 12ax7. duel grays running to 67N7's and dual browns running to the 12AX7's for the heaters.

The driver board, I have a black wire running from ground W2 to the ground area on the power supply board. Is this correct?

I would be very greatfull for any feedback any of you may have. If I don't get any response I will repost this on the audio asylum side. thanks

72.223.12.230

Post a Message!