Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Might have been these things posted by Awe-d-o-file on January 31, 2017 at 17:42:11:
I used DiMarzio 1m interconnects. Have a set of 7. Used matching pairs interconnects for the left and right. The Audioquest Y splitters were very close (?touching) at the back of the processor.
Fascinating about the 7 channel issue. Of course, I was running analog direct stereo, so the other three channels were not being used.
I am curious about Revel in bi-amp mode with regards to your discussion. I doubt the Halcro would have much trouble, even with a 4 ohm load. I will try to measure the the resistance as you suggested. If something interesting emerges, will follow up.
Thank you so much for your thoughtful and helpful response!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Might have been these things - kSpace 18:59:34 01/31/17 (2)
- RE: Might have been these things - Awe-d-o-file 10:28:29 02/02/17 (1)
- RE: Might have been these things - kSpace 11:08:28 02/02/17 (0)