Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: I am pretty sure it cannot work... posted by 3+4=5 on January 17, 2017 at 21:57:37:
There would unquestionably be output. My only question is whether I could typically expect to achieve any enhancement in the common mode interference rejection.This is why I mentioned the schematic for the 651P. Look at page 10 in the pdf in the link. It's the 640p but same thing.
Take the 640p moviong coil inputs, for example, there are 470ohm resistors off pre in left plus to ground and another 470r from pre in right plus to ground. The MM inputs are similar but with 560ks.
If you put coil plus to mc pre in right plus and coil minus to mc pre in left plus tou have effectively placed a 940 ohm in parallel with one coil of your cartridge.
That may not be your carts optimal loading, but if your stuff works, that 970 ohm resistor will get a voltage across it and cause the preamp to function when you play a record, if the premp is working and turned on.
Edits: 01/17/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I am pretty sure it cannot work... - Ugly 22:55:40 01/17/17 (0)