Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Interesting find adding a DIY volume remote posted by airtime on November 11, 2016 at 05:47:39:
I haven't done it. But if I was so inclined would lean towards mechanical solution driven by Arduino components, either belt drive or friction. My guess would be that it would end up around $125.
Another mechanical route would be to use RC components, probably pick up a scrap unit inexpensively. The servo's have a lot or torque.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Interesting find adding a DIY volume remote - fredtr 06:20:39 11/11/16 (5)
- RE: Interesting find adding a DIY volume remote - airtime 06:27:19 11/11/16 (4)
- RE: Interesting find adding a DIY volume remote - fredtr 13:05:10 11/12/16 (2)
- RE: Interesting find adding a DIY volume remote - airtime 17:27:14 11/12/16 (1)
- RE: Interesting find adding a DIY volume remote - fredtr 04:01:42 11/13/16 (0)
- RE: Interesting find adding a DIY volume remote - fredtr 06:52:32 11/11/16 (0)