RE: Yes...

Follow Ups Full Thread

Topic - Can choice of cables cause an amp to blow? - TGR 11:55:28 10/12/16 (71)

RE: Can choice of cables cause an amp to blow? - psn 00:32:12 10/31/16 (0)

RE: Can choice of cables cause an amp to blow? - gordguide 11:47:52 10/26/16 (0)

RE: Can choice of cables cause an amp to blow? - Inmate51 14:02:10 10/14/16 (0)

RE: Can choice of cables cause an amp to blow? - genungo 16:47:16 10/13/16 (0)

RE: Can choice of cables cause an amp to blow? - SgreenP@MSN.com 16:01:29 10/13/16 (0)

More on this - TGR 10:28:03 10/13/16 (9)

RE: More on this - PAR 14:28:55 10/13/16 (0)

What cables does the manufacturer recommend? - hawkmoon 13:50:54 10/13/16 (0)

RE: More on this - BCR 12:45:33 10/13/16 (6)

HaHa - but I have two systems - TGR 15:57:56 10/13/16 (5)

RE: HaHa - but I have two systems - BCR 17:16:51 10/13/16 (4)

RE: HaHa - but I have two systems - airtime 08:16:28 10/14/16 (3)

RE: HaHa - but I have two systems - BCR 11:21:30 10/14/16 (2)

RE: HaHa - but I have two systems - Crazy Dave 08:07:50 10/19/16 (1)

RE: HaHa - but I have two systems - BCR 08:48:17 10/19/16 (0)

This is how I wired my HT setup - airtime 08:07:52 10/13/16 (0)

Yes... - PAR 00:36:29 10/13/16 (36)

Note to self... - AbeCollins 16:46:28 10/13/16 (17)

RE: Note to self... - morricab 09:00:31 10/17/16 (0)

Not poor design, the cable is designed to be part of the network on the output stage - Dave_K 06:59:07 10/14/16 (15)

RE: Not poor design, the cable is designed to be part of the network on the output stage - hahax@verizon.net 10:15:28 10/15/16 (5)

RE: Not poor design -- But New Design Then (So You R Younger than I!) (nt) - goldenthal 16:49:30 10/15/16 (0)

RE: Not poor design, the cable is designed to be part of the network on the output stage - AbeCollins 10:52:44 10/15/16 (3)

RE: Not poor design, the cable is designed to be part of the network on the output stage - gordguide 06:08:25 11/11/16 (0)

RE: Not poor design -- Did Any Such Hi-cap Speaker-wire exist before Cobra? (nt) - goldenthal 16:52:48 10/15/16 (1)

RE: Not poor design -- Sorry, These were meant for Lower re Cobra (nt) - goldenthal 13:59:41 10/19/16 (0)

"designed to be part of the network" sounds like crappola - airtime 08:39:39 10/14/16 (8)

Not crappola if you folow the engineering principles - Dave_K 09:19:04 10/14/16 (7)

Naim speaker cables... - kuma 21:15:57 10/15/16 (0)

Crappola if you adhere to the philosophical principle... - AbeCollins 10:28:16 10/14/16 (5)

Don't give a crap about philosophy, just engineering - Dave_K 11:58:12 10/14/16 (4)

That's the problem with many engineers... - AbeCollins 14:01:30 10/14/16 (0)

No Dave you're wrong - airtime 13:00:06 10/14/16 (2)

You have it backwards - Dave_K 13:36:46 10/14/16 (1)

Reminder to self... - AbeCollins 14:09:41 10/14/16 (0)

RE: Yes... - Ralph 09:43:37 10/13/16 (5)

RE: Yes... Good Example Was Threshold 400A Which Just Shut Down (nt) - goldenthal 16:35:55 10/15/16 (2)

RE: Yes... Good Example Was Threshold 400A Which Just Shut Down (nt) - Crazy Dave 07:48:36 10/19/16 (1)

RE: Yes... Good Example Was Threshold 400A Which Just Shut Down (nt) - goldenthal 13:52:53 10/19/16 (0)

RE: Yes... - BCR 10:02:57 10/13/16 (1)

RE: Yes... Worked OK with My Mc 275 though, but Didn't Sound Better (nt) - goldenthal 16:39:07 10/15/16 (0)

RE: Yes... - Mick Wolfe 08:46:02 10/13/16 (0)

Yur kidding me - right ! - airtime 07:57:14 10/13/16 (10)

RE: Yur kidding me - right! -- Tell Nelson Pass (See Above) (nt) - goldenthal 16:42:09 10/15/16 (2)

I think you missed the point - airtime 08:09:59 10/16/16 (1)

I don't think [I] missed the point -- It is always possible . . . - goldenthal 12:11:03 10/16/16 (0)

Over the years a small number of amp designs have had the same sort of issue. stable only if.... - Smelly_Socks 08:19:57 10/13/16 (6)

RE: Over the years a small number of amp designs have had the same sort of issue. stable only if.... - airtime 08:45:16 10/13/16 (5)

RE: Over the years -- That Wire Design (Capacitance-Be-Damned) Was New & Unepected by Amp Mfrs (nt) - goldenthal 16:46:16 10/15/16 (0)

RE: Over the years a small number of amp designs have had the same sort of issue. stable only if.... - pictureguy 00:08:53 10/14/16 (3)

RE: Over the years a small number of amp designs have had the same sort of issue. stable only if.... - AbeCollins 06:48:16 10/14/16 (2)

RE: Over the years a small number of amp designs have had the same sort of issue. stable only if.... - pictureguy 22:56:29 11/24/16 (0)

What are you reading my mind - airtime 08:08:55 10/14/16 (0)

Not likely unless... - AbeCollins 22:29:51 10/12/16 (3)

RE: Not likely unless... - airtime 07:51:30 10/13/16 (1)

RE: Not likely unless... - AbeCollins 16:41:48 10/13/16 (0)

RE: Not likely unless... - fantja 23:08:04 10/12/16 (0)

RE: Can choice of cables cause an amp to blow? - hahax@verizon.net 20:34:30 10/12/16 (1)

Yep. - Jim Treanor 14:19:45 10/13/16 (0)

Instabilities induced by cables - FenderLover 18:59:12 10/12/16 (0)

ask the folks at Spectral - Curious 17:58:06 10/12/16 (0)

Audio Research - djk 15:51:29 10/12/16 (0)

Yes, if they're shorted! :-) /nt\ - John Elison 14:32:01 10/12/16 (2)

RE: Yes, if they're shorted! :-) /nt\ - Frihed89 00:11:55 10/13/16 (1)

RE: Yes, if they're shorted! :-) - John Elison 07:20:22 10/13/16 (0)

Yes - E-Stat 12:25:03 10/12/16 (5)

RE: "Ideally, do you know the LCR metrics?" - goldenthal 14:12:57 10/19/16 (0)

LCR - Prisoners 13:53:27 10/12/16 (3)

RE: LCR - TGR 13:56:29 10/12/16 (2)

I had some Audioquest cables that were problematic. - Prisoners 16:04:52 10/12/16 (0)

Yes - E-Stat 14:59:45 10/12/16 (0)

Follow Ups

RE: Yes... - Ralph 09:43:37 10/13/16 (5)

RE: Yes... Good Example Was Threshold 400A Which Just Shut Down (nt) - goldenthal 16:35:55 10/15/16 (2)

RE: Yes... Good Example Was Threshold 400A Which Just Shut Down (nt) - Crazy Dave 07:48:36 10/19/16 (1)

RE: Yes... Good Example Was Threshold 400A Which Just Shut Down (nt) - goldenthal 13:52:53 10/19/16 (0)

RE: Yes... - BCR 10:02:57 10/13/16 (1)

RE: Yes... Worked OK with My Mc 275 though, but Didn't Sound Better (nt) - goldenthal 16:39:07 10/15/16 (0)

Post a Message!