Thanks very much. That's too easy. My system pictured is in my

Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

second home, and I am not there right now to access my manual. Using the manual's formula, I needed a very small resistor to slightly change my desired crossover point, but I don't remember reading how to attach the resistors in those tubes. Many thanks for the explanation.

My sub amp is a NAD 2600A, and the subs/woofers? are a pair of really inexpensive Polk RM1000 speakers spiked on cement slabs with lots of lead weight on top. My main speakers are Hitachi HS-500s.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Dahlquist DQ-LP1 Electronic Crossover - Lew 18:08:29 09/13/16 (9)

Lew, sorry if I derailed your post. I hope that some of the answers - alaskahiatt 17:28:44 09/15/16 (0)

RE: Dahlquist DQ-LP1 Electronic Crossover - louie3 08:10:36 09/14/16 (6)

RE: Dahlquist DQ-LP1 Electronic Crossover - kentaja 13:39:29 09/14/16 (1)

RE: Dahlquist DQ-LP1 Electronic Crossover - louie3 13:57:27 09/14/16 (0)

I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. - alaskahiatt 10:12:33 09/14/16 (3)

RE: I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. - louie3 10:49:59 09/14/16 (2)

Thanks very much. That's too easy. My system pictured is in my - alaskahiatt 11:42:26 09/14/16 (1)

RE: Thanks very much. That's too easy. My system pictured is in my - louie3 12:34:55 09/14/16 (0)

RE: Dahlquist DQ-LP1 Electronic Crossover - BCR 02:42:02 09/14/16 (0)

Follow Ups

Thanks very much. That's too easy. My system pictured is in my - alaskahiatt 11:42:26 09/14/16 (1)

RE: Thanks very much. That's too easy. My system pictured is in my - louie3 12:34:55 09/14/16 (0)

Post a Message!