Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Dahlquist DQ-LP1 Electronic Crossover posted by Lew on September 13, 2016 at 18:08:29:
The LP-1 input impedance is adjustable.
The factory setting is for 75 to 100 K ohm amps.
This setting influences the crossover point. You gotta read the manual carefully.
FWIW: I have one of these I have used for years. I do NOT run the top end through it any more, even with a quality cap in the top end section, I can hear a difference in transparency.
But even so, I find the LP-1 at least as good, even full range, as any other electronic crossover available, and way better than most.
It is possible that a better cap could convince me to run the top end through the LP-1, but I have not bothered.
Just running the subs with it now.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Dahlquist DQ-LP1 Electronic Crossover - louie3 08:10:36 09/14/16 (6)
- RE: Dahlquist DQ-LP1 Electronic Crossover - kentaja 13:39:29 09/14/16 (1)
- RE: Dahlquist DQ-LP1 Electronic Crossover - louie3 13:57:27 09/14/16 (0)
- I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. - alaskahiatt 10:12:33 09/14/16 (3)
- RE: I have a fully upgraded LP1 in my system, but I need help with adjusting resistance. - louie3 10:49:59 09/14/16 (2)
- Thanks very much. That's too easy. My system pictured is in my - alaskahiatt 11:42:26 09/14/16 (1)
- RE: Thanks very much. That's too easy. My system pictured is in my - louie3 12:34:55 09/14/16 (0)