Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Any reason besides safety to keep the lid on,,, posted by popsy on August 21, 2016 at 13:23:05:
when I worked in a semiconductor fab as an equipment guy, I was REQUIRED by good practices to replace every fastener I removed.
One buddy was working on an RF generator, used to generate a plasma in a tool, when an idiot dropped their (stainless steel) tweezers INTO and ON the circuit board, reached in a plucked them OUT. No smoke, flames, zaps or ANYTHING.
Other people, leaning over active, high power RF circuits have been medically damaged by so doing.
At least SS doesn't have the wacky voltages common in tube gear.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Any reason besides safety to keep the lid on,,, - pictureguy 00:11:09 08/27/16 (0)