Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Dynaco QSA-300 posted by dpsutphin on July 6, 2016 at 13:06:54:
Channels A and B share the same board?
To minimize crosstalk and optimize power supply effectiveness (since rear channel power requirement is typically lower), I think it would be a good idea to run channels A and C off the same board and power supply.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Are you sure that - E-Stat 15:06:23 07/06/16 (1)
- RE: Are you sure that - dpsutphin 18:16:06 07/06/16 (0)