|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: aaahhhhh yesss..... posted by jrdoe on May 6, 2016 at 19:27:17:
Find and Buy a 10k pot (stepped attenuator or not.. don't spend large as there is NO need to.. salesmens' babbles aside).
Run Short interconnects to your 'new' pot... from Source And to Amp. Then LISTEN,
If it works... as in your existing gear is impedance compatible (likely) AND up to it. Gotta be resolving enough to bother with :-)
Then you will Never want to go back to a Pre with gain.. nor should you need to.
Unless using a Turntable.. which then involves a discrete Phono Gizmo..feeding your pot.. which is a Good idea no matter what.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Sighhh. - bare 20:11:46 05/06/16 (1)
- NO passive output cables works great - genungo 13:49:10 05/07/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
