|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Replace separates with integrated? posted by mtbikeNH on May 3, 2016 at 09:34:20:
I have been down the route of taming brightness, it is fraught with pitfalls. From my experience, changing to a "warmer" integrated may not get you the sound you want, you could end up with a sound that is too soft and woolly. The first thing to do is change the source. With brightness, usually the culprit is a digital source. With analog it's easier to fix because you can always install a warm cartridge. Then, choose your integrated. Good luck.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: First replace the source, it's always the source - ydavid 12:46:33 05/04/16 (1)
- RE: First replace the source, it's always the source - mtbikeNH 07:25:40 05/05/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
