Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Safely testing a pre/power amp posted by graciouslee on February 9, 2016 at 00:39:05:
0 mVdc unless manufacturer says different like in the case of my Edge M8 it's suppose to be set from 0 mVdc to -10 mVdc. DC offset jumps around as AC line voltage varies. So try your best to get as close to 0 mVdc
Sometimes adjusting will affect the bias setting so you MAY have to adjusted as well just depends on how far out the DC offset is.
Hope this helps.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- DC offset should always tried to be set to..... - Cougar 19:27:40 02/09/16 (1)
- RE: DC offset should always tried to be set to..... - graciouslee 07:00:29 02/10/16 (0)