Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: not only does amplifier senstivity play a role posted by Ralph on February 8, 2016 at 12:53:47:
Yes I've had my 2.35 VRMS @50 ohms through a resistor ladder to a passive bi amp where each amp has an input impedance of 100K where 2V will deliver full power.
There is a rare occasion when a CD recorded at a low level will not allow me to light my peak lights on any passage of the music.
With my 4 mV Grado, 54dB gain phono pre @1000 ohms I was also fine with a few occasions where a few recordings could have used a bit more umph.
ET
ET
"If at first you don't succeed, keep on sucking till you do suck seed" - Curly Howard 1936
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: not only does amplifier senstivity play a role - Awe-d-o-file 12:24:24 02/09/16 (0)