Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Stereo Buffer with Parallel Connection Question posted by Dimitry on September 30, 2015 at 10:49:22:
"are there any potential issues running the stereo buffers in this "summed parallel" mode"Yes.
It's fine to feed both inputs with the same source but it's not OK to tie the two outputs together. That "shorts out" each of the two outputs.
The low output impedance of one stage is seen by the other and visa versa.
That low impedance is too low for the unit to properly drive.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
Edits: 09/30/15
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Stereo Buffer with Parallel Connection Question - Tre' 13:21:45 09/30/15 (1)
- RE: Stereo Buffer with Parallel Connection Question - Dimitry 13:35:35 09/30/15 (0)