Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Parasound Halo integrated: Anyone experiment with speaker crossover? posted by tketcham on September 26, 2015 at 06:56:48:
First, I have the P5 preamp from Parasound. I suspect the crossover / bass managment is either identical or a close sib.
I cross my panels over about 60hz using the Parasound crossover which is 12db/ octave. i run the sub output Full Range and allow the sub to low pass at about 45hz or so.
I the 2 keys are First, to not cross over too high. Second, dont' set high and low pass at the same frequency or you'll have a 'bump'. Set the low, lower and the high higher so they stand a good chance of SUMMING FLAT at the crossover point.
My Panels sound very nice, much more spacious image and extension to below 20hz. The reduction in power needed in the low bass to the panels really helps the amp AND the speakers.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Parasound Halo integrated: Anyone experiment with speaker crossover? - pictureguy 09:53:48 09/26/15 (6)
- RE: Parasound Halo integrated: Anyone experiment with speaker crossover? - tketcham 18:38:24 09/26/15 (5)
- RE: Parasound Halo integrated: Anyone experiment with speaker crossover? - pictureguy 20:09:58 09/26/15 (4)
- Integrated as a power amp... - tketcham 06:29:05 09/27/15 (3)
- RE: Integrated as a power amp... - pictureguy 00:25:34 09/28/15 (2)
- RE: Integrated as a power amp... - tketcham 09:41:13 09/28/15 (1)
- RE: Integrated as a power amp... - pictureguy 10:08:19 09/28/15 (0)