Home Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

RE: There's more than one way to do that...

In a solid state amplifier, the output devices have a non-linear capacitive aspect built into the junctions. This capacitance is magnified by current
- Ralph


You talking BJT and or MOSFETS, High bias Mosfets dont have this issue , just crank the bias up to reduce. Seriously Ralph, junction capacitance is easily controlled. Tube amplifiers also suffer from parasitic capacitance like anything else.

As to speaker wires, we have progressed beyond zip cable at Lafayette, RLC circuits (speaker wires) are available to care of any situation, speakers wires should be short anyway, .5M is about the best , 1M is the max regardless if 8/4/2 ohms , not to mention most good SS amps have pretty low output impedances ....


Regards



Edits: 09/18/15 09/18/15

This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.