Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Again, posted by pictureguy on August 16, 2015 at 13:52:33:
Really? You did mention the amp "only" weighted 25lb and mentioned that there was thus some "compromise". I don't know about you, but my interpretation of what you implied was that the amp was too light (not enough heat sink) to perform properly long term given the output. Did I misunderstand your inference?
And Hypex has also repeatedly said that no heat conducting compound is necessary. Just bolt it to the case and you are good to go.
I can't speak for all class d manufacturers, but regarding Hypex, 25lb is no indication of any compromises or less than robust performance.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- " I don't know if the reviewer noted the compromise involved with a 400-a-side amp of only 25lb. " - kuribo 14:18:13 08/16/15 (13)
- RE: " I don't know if the reviewer noted the compromise involved with a 400-a-side amp of only 25lb. " - pictureguy 15:11:47 08/16/15 (12)
- Ok, I won't use my ncore for a shaker table....Thanks. - kuribo 15:19:49 08/16/15 (11)
- RE: Ok, I won't use my ncore for a shaker table....Thanks. - pictureguy 17:51:09 08/16/15 (10)
- RE: Ok, I won't use my ncore for a shaker table....Thanks. - Mr Peabody 21:22:33 08/16/15 (2)
- RE: Ok, I won't use my ncore for a shaker table....Thanks. - pictureguy 22:05:22 08/16/15 (1)
- RE: Ok, I won't use my ncore for a shaker table....Thanks. - Mr Peabody 04:23:12 08/17/15 (0)
- Heat doesn't kill, it shortens the lifetime. Excessive heat kills... - kuribo 20:04:46 08/16/15 (6)
- RE: Heat doesn't kill, it shortens the lifetime. Excessive heat kills... - pictureguy 21:25:58 08/16/15 (5)
- It is what it is... - kuribo 06:30:30 08/17/15 (4)
- RE: It is what it is... - dbphd 08:48:56 08/17/15 (3)
- RE: It is what it is... - A.Wayne 08:08:37 08/20/15 (1)
- RE: It is what it is... - dbphd 18:02:42 08/21/15 (0)
- RE: It is what it is... - pictureguy 10:24:32 08/17/15 (0)