Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
I'm planning to use 2 channels of a 3 channel Proceed HPA 3 amp to drive a pair of KEF LS50s. There will be no signal nor load for the center channel. In the past when I've used the amp for 2 channels, I've connected a center speaker even though there was no signal. IIRC, Madrigal told me their amps are stable even without loads. but that was decades ago so I may be a bit hazy in my recollection. Will implementing my plan harm the amp?
db
This post is made possible by the generous support of people like you and our sponsors:
Topic - unloaded amp - dbphd 21:46:43 08/15/15 (4)
- RE: unloaded amp - pictureguy 09:54:42 08/16/15 (2)
- RE: unloaded amp - b.l.zeebub 04:34:06 08/17/15 (0)
- RE: unloaded amp - dbphd 11:02:57 08/16/15 (0)
- RE: unloaded amp - Blackdog 05:17:25 08/16/15 (0)