|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Burned resistor in Premier 12 posted by Jack D II on June 7, 2015 at 10:15:47:
Or you can get the resistor value from the other amplifier. Schematics are always nice, but tube amplifiers are easy to service. See what the resistor is connected to, probably a tube, and lookup the pinout. Variac's are nice for this type of problem, bring the voltage up slowly to diagnose the cause. If you need help, post this to one of the more technical categories, like tube DYI and see if there is someone close by that will help you.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Burned resistor in Premier 12 - fredtr 16:01:39 06/09/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]