Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Correction, with apologies posted by murali on May 23, 2015 at 22:03:06:
If it were me, I'd get the processor out of the system and use just the linestage and power amp.... and a simple source like a CDP. Begin troubleshooting to determine if you have any channel imbalance between the L&R channels.... and be sure that your linestage balance control isn't offset.
IMHO, processors have too many variables that can be incorrectly set so that's the first item I would set aside and remove from the system to simplify the troubleshooting.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Correction, with apologies - AbeCollins 23:29:09 05/23/15 (0)