Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
I have 2 Dynaco mkIII's I am restoring. One has a bad power x-former. I need input on replacing X-formers. Should I replace both the power and the audio output transformers so they would be matched? Just the power? I haven't dug into the 2nd amp, if the x-formers on that component are good should I leave well enough alone? Or, again to have a matched pair should I replace them also. I'm interested to what everyone has to say.
Thanks,
Gronboi
RSTucker
This post is made possible by the generous support of people like you and our sponsors:
Topic - advice - Gronboi 11:20:09 04/22/15 (11)
- RE: advice - fredtr 12:39:25 05/02/15 (0)
- RE: advice - Palustris 09:55:03 04/28/15 (1)
- RE: advice - Gronboi 05:35:33 04/30/15 (0)
- RE: advice - sayntjack 23:41:17 04/27/15 (1)
- That explains a lot - jedrider 08:52:24 04/28/15 (0)
- The power transformer is not matched to the output....... - viridian 21:24:56 04/23/15 (0)
- Also check Bob Latino's site as well - airtime 06:25:14 04/23/15 (0)
- RE: advice - fantja 16:38:32 04/22/15 (0)
- RE: advice - jedrider 12:43:25 04/22/15 (0)
- RE: advice - Mick Wolfe 12:41:59 04/22/15 (1)
- Or... - mkuller 14:34:51 04/22/15 (0)