RE: Balanced connections and ground loops.

Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Posted by beppe61 (A) on April 13, 2015 at 05:15:51

In Reply to: RE: Balanced connections and ground loops. posted by AbeCollins on April 10, 2015 at 07:53:22:

Hi and thanks a lot indeed for the very valuable directions.
Problem is that i move things and change equipment.
And also i change flats and the electrical plant is not always perfectly built.
The lack of noise is a very nice experience.
It is a very relaxing experience instead buzz and hum everytime.
I also hope to save a little on cables, because i have the feeling that xlr are less critical than rca cables.
At present i am doing some tests on not very expensive xlrs.
Thanks again.

Kind regards,
bg

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Balanced connections and ground loops. - beppe61 00:21:44 04/10/15 (17)

home theater - Ralph 08:47:57 04/10/15 (4)

RE: home theater - beppe61 05:27:00 04/13/15 (0)

RE: home theater - Awe-d-o-file 14:09:47 04/10/15 (0)

Or, simply... - E-Stat 11:19:42 04/10/15 (1)

Bad grounding of cable inputs is a common problem. (NT) - Kal Rubinson 16:25:13 04/12/15 (0)

Here Ya Go - Inmate51 08:04:00 04/10/15 (3)

RE: Here Ya Go - beppe61 05:21:19 04/13/15 (2)

RE: Here Ya Go - Inmate51 11:10:45 04/13/15 (1)

RE: Here Ya Go - beppe61 04:41:16 04/14/15 (0)

RE: Balanced connections and ground loops. - AbeCollins 07:53:22 04/10/15 (1)

RE: Balanced connections and ground loops. - beppe61 05:15:51 04/13/15 (0)

RE: Balanced connections and ground loops. - John Elison 00:30:24 04/10/15 (5)

The only time I encountered such - E-Stat 06:30:22 04/10/15 (0)

RE: Balanced connections and ground loops. - beppe61 05:12:31 04/10/15 (2)

You can make it work - Ralph 08:44:31 04/10/15 (1)

RE: You can make it work - beppe61 04:59:33 04/13/15 (0)

RE: Balanced connections and ground loops. - pictureguy 01:15:19 04/10/15 (0)

Follow Ups

RE: Balanced connections and ground loops. - beppe61 05:15:51 04/13/15 (0)

Post a Message!