|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: 250W IR Class D amp - with Mudorf M-Lytic Caps posted by samac on March 27, 2015 at 17:52:17:
The tranni is 300VA @ 40-0-40. It will deliver 3.75A. It does look small against the massive caps. When I had the PS finished I powered it up to test it. But when I turned it off it did not discharge. So I got a 100ohm 10W resistor to discharge it. Instead of a spark I could draw out a long blue flame. And it made a fluttering sound. I have never seen anything like this before.
The caps have Sili-pads on the bottom to allow bolting to heatsinks. As I said I'm not sure if the caps are part of the sound but if music is playing and I turn the amp off it runs for about another 30seconds! The caps are very low ESR types.
| retro-thermionic |
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 250W IR Class D amp - with Mudorf M-Lytic Caps - mwhouston 18:34:27 03/27/15 (4)
- RE: 250W IR Class D amp - with Mudorf M-Lytic Caps - samac 18:47:54 03/27/15 (3)
- RE: 250W IR Class D amp - with Mudorf M-Lytic Caps - mwhouston 18:55:17 03/27/15 (2)
- RE: 250W IR Class D amp - with Mudorf M-Lytic Caps - samac 18:46:08 03/28/15 (1)
- RE: 250W IR Class D amp - with Mudorf M-Lytic Caps - mwhouston 00:34:54 03/29/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
