Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Good passive preamp for Quicksilver amps posted by radknee on November 6, 2014 at 13:38:46:
QS amps have a lower sensitivity than, say, solid state units. Most ss units.need only .875 volts to reach full lower. Most QS amps need 1.5 volts.
Most DACs put out only 2 volts....
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Good passive preamp for Quicksilver amps - unclestu 14:01:05 11/06/14 (1)
- RE: Good passive preamp for Quicksilver amps - radknee 13:37:05 11/07/14 (0)