|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Most speakers posted by Jon L on October 15, 2014 at 14:47:13:
"A speaker advertised as "87 dB and 4 Ohms" more often than not actually measures more like 84 dB dipping into 2 Ohms easily in large portions of the frequency response."
This is another reason the Ncore's ultra low output impedance is helpful, being 1 milliohm at 16kHz and below. Note it is reportedly not affected by frequency throughout most of the audio band, raising to only 2.5 milliohm at 20kHz.
The first time I had the Atsah's here, I hooked them up with good quality Furutech cords with Oyaide connectors, placed them on amp stands and used large brass pucks on top to help control resonance. I am sure the milled aluminum enclosures also help control resonances, and may be one reason some report those larger amps to sound better than the 200 wpc NC400's.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Most speakers - mitch2 18:27:50 10/15/14 (5)
- RE: Most speakers - John Elison 20:22:10 10/15/14 (4)
- RE: Most speakers - E-Stat 07:36:30 10/16/14 (3)
- RE: Most speakers - mitch2 19:03:27 10/16/14 (2)
- Exactly - E-Stat 07:05:11 10/17/14 (1)
- RE: Exactly - b.l.zeebub 13:21:22 10/17/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
