Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Counterpoint SA 1000 Moving Coil Settings posted by theaudiohiffle on September 24, 2014 at 17:08:00:
Okay, so I spoke to the man. Bad news is that he sold his business about the same time that the Counterpoint thousand series was introduced, so he had no direct experience with the 1k. On the other hand, I described the two sets of four-pin jumpers and how it appeared that LO was on pins one and two, and that the question was whether or not HO was on pins 2 and 3, or on pins 3 and 4. He replied that HO would almost certainly be on pins 3 and 4. He has more than a bit of experience/knowledge in repairing and building amps, and his further comment was that the chances the two settings would share a pin were slim to none. So, again, FWIW, that's alls I know. Hope this somehow helps.
Mike
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Counterpoint SA 1000 Moving Coil Settings - Sondek 11:48:59 09/25/14 (1)
- RE: Counterpoint SA 1000 Moving Coil Settings - theaudiohiffle 20:51:59 09/26/14 (0)