|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Why solid state sounding tubes? posted by DAVID on September 10, 2014 at 09:45:13:
You can't roll BJTs or FETs.....realistically.
Tube rolling is a convention.
Every ARC schematic I've seen has transistors hanging off the tube...go figure.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Because... - wheezer 12:33:26 09/11/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
