|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Why solid state sounding tubes? posted by DAVID on September 10, 2014 at 09:45:13:
I find that when you bi-amp, the differences are not as noticeable. In my opinion, the best is to use SS for the bass (500Hz or lower), and tubes for the mids and highs. You get the great damping factor of SS for the bass, and the warmth of tubes for the mids.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Why solid state sounding tubes? - Hornlover 08:19:00 09/11/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
