|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Berning posted by Tubegroover on July 29, 2014 at 20:34:05:
The original pot was 47kohms input impedance. I researched opinions and found Dact and Goldpoint to be the most highly rated stepped attenuators. Several people had compared them head to head and found little to no difference between them. I settled on a Dact stereo 50kohm attenuator. One criticism of stepped atenuators is that the steps may not be placed at the volume levels convenient to your particular system and listening levels(step loudness increases too much between steps). I have had no such problems. The improvement in sound is comparable to a major component upgrade/change. Best bang-for-the-buck upgrade I've made by far
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Berning - jayarr 06:15:49 07/30/14 (1)
- RE: Berning - Tubegroover 13:32:47 07/30/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
