|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Is there a way to check amplifier output at the speaker terminals ? posted by dcuhl on June 29, 2014 at 07:01:53:
If the pre has a setting for stereo/mono, set it to mono.
If it has dual Vpots, take your Vac measurement at the end of the ICs first.
Use the Vpots to match the output accordingly.
For single Vpots, still check the ICs Vac at the amp end.
Cheers,
W
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Is there a way to check amplifier output at the speaker terminals ? - wheezer 14:07:54 06/29/14 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
