Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Will ARC VT50 drive Matrix 805? posted by AbeCollins on April 20, 2014 at 10:56:52:
Good point. I looked at the B&W owner's manual and it says the power handling is "Suitable for amplifiers with 50 to 120W output into 4 ohms"
ARC's specs say "POWER OUTPUT: 45 watts per channel continuous from 30Hz to 15kHz. 1kHz total harmonic distortion typically 1% at 45 watts, below .05% at 1 watt."
I don't see the typical watt rating at 8 ohms followed by the 4 ohm rating. Thanks again.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Will ARC VT50 drive Matrix 805? - TheBrewmaster 11:35:12 04/20/14 (4)
- RE: Will ARC VT50 drive Matrix 805? - Duster 15:25:11 04/20/14 (0)
- RE: Will ARC VT50 drive Matrix 805? - AbeCollins 12:21:03 04/20/14 (2)
- RE: Will ARC VT50 drive Matrix 805? - TheBrewmaster 13:40:07 04/20/14 (1)
- RE: Will ARC VT50 drive Matrix 805? - AbeCollins 13:54:37 04/20/14 (0)