Home Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

RE: You are missing the obvious

Those load dependent effects can also interact with the non-linear properties of the amplifier by impacting feedback, affecting stability, etc... My belief is that amplifiers and speakers (and associated wiring) should be evaluated as pairs, not evaluated separately.

I don't know why, but that solid-state edge seems to be prevalent at power up, but with the solid state equipment that I happily use, it's gone after the equipment has been powered up for 24-48 hours. IMO, solid state equipment should be run 24-7 for best sound. This does not appear to shorten product lifetimes and may possibly extend the lifetime of components by reducing the number of thermal cycles and power transients. Electric cost can be a factor, however, particularly in the summertime.

Tony Lauck

"Diversity is the law of nature; no two entities in this universe are uniform." - P.R. Sarkar


This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.