|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Problem with output at the 16 ohm tap posted by whitese on August 7, 2012 at 09:52:01:
.
The voltage output should go up as the tap goes up so the power to the load remains the same.
The voltage from the 16 ohm tap should be 1.4 times higher than that from the 8 ohm tap.
.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- how did you determine that? - bwb 12:45:27 08/07/12 (5)
- RE: how did you determine that? - whitese 12:49:26 08/07/12 (4)
- RE: how did you determine that? - bwb 14:08:34 08/07/12 (3)
- RE: how did you determine that? - whitese 14:26:27 08/07/12 (1)
- RE: how did you determine that? - bwb 08:41:07 08/08/12 (0)
- RE: how did you determine that? - whitese 14:12:15 08/07/12 (0)
[Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2013, Audio Asylum, all rights reserved ] [ Take5 ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]
