Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: It incorporates "Zero-Attack" limiters, that is clipping control and signal compression. Power output is posted by cfb on July 2, 2011 at 08:39:57:
care about the continuous sinusoidal power output of an amplifier when the second by second peak to RMS ratio of a music signal rarely - even Wakefield's Synthesizers - drop to less than 13dB. A 13dB power difference is a ratio of 20:1. Yes, in the old days of Hi-Fi (before the IEC specification started being used) peak power ratings were abused - almost as bad as Behringer does here - often arbitrary. But for todays amplifiers, Amplifiers shoul be rated with a crest factor - how much above the rated power voltage into a typical loudspeaker load (not a resistor) will the voltage be able to swing until current is limited - or a certain level of non-linearity is reached.
"The hardest thing of all is to find a black cat in a dark room, especially if there is no cat" - Confucius
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Yes, but why would you ever - BigguyinATL 10:33:05 07/07/11 (0)