Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Planar Speaker Asylum ]
[ Alert Moderator ]

RE: 3.6R crossover mods

Thanks Davey, I'll take that as a compliment :)

Of course with the exception of the tweeter and binding post terminals the silver solder is kind of redundant. After twisting the wires together I could not budge those connections with my fingers, so the contact was made between wire ends, cap ends and inductor ends, and the solder is just there to hold it tight together over time of course. No current should flow through it anyway, but I already had that Cardas silver solder from 10 years ago when I put the proper binding posts on them and got rid of the fuses and resistor circuit.

Do you have any idea what the stock inductors LCR was by chance? I was going to buy a low ohmmeter out of curiosity but refrained. I might grab the .82 mH one and take it to an electronics repair shop and ask if they would measure it for me.

This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  

Follow Ups Full Thread
Follow Ups
FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]