In Reply to: RE: IRE: Magneplanar MG-II panel vibration problem at low frequency posted by viperz on December 18, 2016 at 15:50:00:
So just a quick update - bending was a no-help at all. I followed Magnepan instructions that someone posted on AK - apply 100-170 lbs through a towel onto the crossbars (from the Mylar side).
Made zero difference. Popped some staples where the outer frame is stapled, had to fix that...
Oh well. And I was running Rotel RMB-1075 amp, which according to S&V magazine goes into clipping around 260 Watts per channel into 4 Ohms. I wasn't clipping obviously, but I was playing close to reference level on the preamp.
I'll put these together and get rid of them. I just don't know what else I can do to this pair.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: IRE: Magneplanar MG-II panel vibration problem at low frequency - viperz 15:23:19 01/05/17 (2)
- RE: IRE: Magneplanar MG-II panel vibration problem at low frequency - Satie 07:53:42 01/06/17 (1)
- RE: IRE: Magneplanar MG-II panel vibration problem at low frequency - viperz 11:40:59 01/06/17 (0)