In Reply to: active crossover install posted by tberd on October 12, 2016 at 06:44:50:
When you say you ran the Magnepan stock settings, did you follow Magnepan's recommendation for active biamping? If so, it will not sound right. You need to emulate the OEM which means a 4th order (L-R) LP at 280 hz (not 3rd order at 250 hz) and a 1st order HP at 200 Hz.
The next question is what amps? Are they the same, and, if not, were the gains matched?
Finally, the obvious, were the cables connected correctly and the correct jumpers removed. It's real easy to reverse polarity or even direct the low end to the mid-tweeter (trust me I have been there).
I would not blame the cables and connectors if they sounded good with a single amp setup.
Also, A SET amp probably is not the answer as Maggies just love muscle. I do agree that a tube preamp (with SS amps) seems to work well.
"Our head is round in order to allow our thoughts to change direction." Francis Picabia
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: active crossover install - neolith 07:31:47 10/12/16 (2)
- Clarification and explanation - neolith 15:26:42 10/12/16 (0)
- RE: active crossover install - Roger Gustavsson 09:09:47 10/12/16 (0)