In Reply to: glues have improved but maybe not so for the mylar posted by Green Lantern on October 4, 2016 at 16:55:10:
On my old MG-IIIas, one of the curved reinforcing bars had come loose from the 'holey metal' at one end - and this made a buzz at certain frequencies.
My solution was to re-glue but also bolt the reinforcing bar to the sheet - and I did it for each end of every reinforcing bar.
If the buzz goes away when you press the end of the reinforcing bar against the metal sheet ... then that's the problem!
Regards,
Andy
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: it may not be a wire-on-mylar buzzing? ... - andyr 17:33:54 10/10/16 (0)