In Reply to: RE: MGIII active crossover? posted by Skeepowder1@aol.com on August 3, 2016 at 19:58:36:
Since you found the effective XO as 500hz according to magnepan then you should set your symmetrical 3rd order there and are likely to get the best results that way.
The other option is to just follow magnepan's biamp directions and just use the XM9 as a low pass filter and use a 1st order line level which simply amounts to a series capacitor calculated according to the mid/tweeter amp input impedance.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: MGIII active crossover? - Satie 16:34:12 08/04/16 (21)
- RE: MGIII active crossover? - Skeepowder1@aol.com 18:08:46 08/04/16 (20)
- RE: MGIII active crossover? - Satie 20:28:51 08/04/16 (18)
- RE: MGIII active crossover? - Skeepowder 07:00:37 08/05/16 (17)
- RE: MGIII active crossover? - Norman M 08:12:30 08/05/16 (16)
- RE: MGIII active crossover? - Skeepowder 15:00:18 08/05/16 (15)
- RE: MGIII active crossover? - Satie 04:09:25 08/06/16 (14)
- RE: MGIII active crossover? - Skeepowder 16:41:36 08/06/16 (13)
- RE: MGIII active crossover? - Satie 04:41:26 08/08/16 (12)
- RE: MGIII active crossover? - Skeepowder 09:26:42 08/08/16 (11)
- RE: MGIII active crossover? - Satie 09:32:46 08/08/16 (10)
- RE: MGIII active crossover? - Skeepowder 19:04:50 08/08/16 (9)
- RE: MGIII active crossover? - Satie 22:00:51 08/08/16 (1)
- RE: MGIII active crossover? - BDP24 01:09:10 08/09/16 (0)
- RE: That link to the XOs ... - andyr 20:35:11 08/08/16 (6)
- RE: That link to the XOs ... - Skeepowder 08:33:08 08/09/16 (5)
- RE: That link to the XOs ... - Skeepowder 08:55:21 08/11/16 (4)
- RE: That link to the XOs ... - Satie 16:09:13 08/12/16 (3)
- RE: That link to the XOs ... - Skeepowder 16:59:17 08/12/16 (2)
- RE: That link to the XOs ... - Satie 06:46:56 08/13/16 (1)
- RE: That link to the XOs ... - Skeepowder 08:19:12 08/13/16 (0)
- RE: MGIII active crossover? - Skeepowder1@aol.com 18:41:02 08/04/16 (0)