In Reply to: RE: Active bi-amping of ET LFT-8b posted by BDP24 on July 2, 2016 at 16:28:27:
Yes the cards do all the changes, but you still need to solder the parts for each freq and slope into the card. And if you want to reuse the card for a different freq or slope you need to desolder the old parts out and put the new parts in. If you don't recycle them then you end up with a big pile of freq cards. I tried using micro pots (wirewound) but they were difficult to turn precisely and have no calibration marks.
If you end up with the tweeters just 3' off the front wall then you will need to do some absorption or quite a bit of diffusion over the wall.
Lots of things to try out.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Active bi-amping of ET LFT-8b - Satie 00:14:24 07/03/16 (9)
- RE: Active bi-amping of ET LFT-8b - BDP24 03:18:40 07/03/16 (8)
- RE: Active bi-amping of ET LFT-8b - Satie 03:44:44 07/03/16 (7)
- RE: Active bi-amping of ET LFT-8b - BDP24 13:29:31 07/05/16 (6)
- RE: Active bi-amping of ET LFT-8b - Satie 21:00:18 07/05/16 (5)
- RE: Active bi-amping of ET LFT-8b - BDP24 16:11:14 07/07/16 (4)
- RE: Active bi-amping of ET LFT-8b - Satie 07:04:28 07/08/16 (3)
- RE: Active bi-amping of ET LFT-8b - BDP24 14:11:48 07/11/16 (2)
- RE: Active bi-amping of ET LFT-8b - Satie 19:20:39 07/11/16 (1)
- RE: Active bi-amping of ET LFT-8b - BDP24 01:53:05 07/13/16 (0)