In Reply to: RE: brown to red posted by DTS ma 7.2 on April 4, 2016 at 15:03:36:
Correct me if I inferred incorrectly, but I took it that the photo on the right is of your unmolested connector plate. The upper pair receive the wires from your amp. The lower pair are made with either a jumper or a resistor. To the left is the fuse. Just follow the wiring (through the resistor/jumper and the fuse) and to what is the brown wire currently 'connected' - the red. Placing the brown wire on the other side of the fuse and resistor bypasses them.Davey's suggestion is the same, except that it preserves the resistor. My suggestion doesn't require you to cut anything, but it does eliminate the resistor as well as the fuse.
Edits: 04/04/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: brown to red - wazoo 17:43:08 04/04/16 (3)
- RE: brown to red - DTS ma 7.2 18:02:02 04/04/16 (2)
- no, read Davey's post - wazoo 18:18:15 04/04/16 (1)
- RE: no, read Davey's post - DTS ma 7.2 06:23:53 04/14/16 (0)