|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: 3.6R's vs.1.7's posted by Satie on March 26, 2016 at 14:20:47:
With the crossover at 200hz and 1700hz, a BIAMP between lows and mid-tweet would only need maybe 40% below and 60% above the 200hz point.
You Could make very good use of a PAIR of stereo amps, one per speaker. 200x2@8 would not be a bad place to start. And better use of power would be had by going 'active' and making or buying a line-level crossover which would yield maybe 2db+ in this situation.
And using MODERN DSP stuff, it wouldn't be impossible to TRIamp. Perhaps start with duplicating the speakers crossover, just to get on the page. Modify later to hearts-content.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 3.6R's vs.1.7's - pictureguy 17:34:39 03/26/16 (2)
- It's easy to biamp these, as... - MWE 18:27:00 03/26/16 (1)
- RE: It's easy to biamp these, as... - rosendds@frontiernet.net 05:38:45 03/27/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
