Home Planar Speaker Asylum

Welcome! Need support, you got it. Or share your ideas and experiences.

RE: Class D , Class-a , Zmin and phase is Very important

Technically speaking you can only have a full class-A amp at 8 ohm and higher , so for most their is no such thing as full class -a( ok talking about DC , SS amps ) when you have a z-min of 4 ohm and lower. How much bias is actually necessary is very much dependent on when the amp slides out of class-a on a particular setup. impedance , sensitivity and typical listening levels play a big role here, if you listen at relatively low levels on a high sensitivity speaker , you will most likely favor an amplifier running high class -a bias into that Zload , with low sensitivity speakers at a moderate to high listening level , not so much..

On a pr of scinnies we lowered the bias considerably on a KSA200 , it takes time, there's no magic number, bias is gradually increased and adjusted for best sonics , at the listening levels required , we ended up with a relatively cool running Krell and speed galore , the dynamic contrast we were able to obtain was fantastic compared to it's original hi bias operation , much more life and energy to the music ...

Good Class-D has this jump factor in spades , SET's too , it is one of the main reasons i keep a close ear to class-d , unfortunately and like SET 's , their ( class-D) sonics are very much impedance dependent and only the Devialets dont seem to have this issue , but they also dont have the high jump factor .






This post is made possible by the generous support of people like you and our sponsors:
  VH Audio  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.