|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Anti-cables... posted by neolith on January 28, 2016 at 18:28:09:
I agree except for ONE minor point.
If the crossover is near the 50:50 power point of about 350hz, than I'd say to use the SAME size wire for both runs.
At some high or low frequency when the power ratio from hi:lo or lo:hi is 30:70 or so, THAN I'd go with heavier wire on the side which needs more power.
My Panels cross at 600 and I run identical but only 4' runs to each 'side'. In an ideal setup, I could see needing only 2' per run which might make 'what wire?' a moot point.
That's a total of 16'/4=4ft per run.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Anti-cables... - pictureguy 00:16:16 02/03/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
