|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Active crossover for ET-LFE8b posted by Davey on October 12, 2015 at 07:11:35:
Slight typo, it should have read 4.7 uF cap (the by-pass cap on the 470 mF electrolytic). Also I should have mentioned jumping the inductor on the woofer - again, just a simple replacement of the inductor with a wire.BTW, the manual suggests using a 180 Hz HP filter (not 30 Hz) for biamping. I suspect this is because the "balancing" of inherent woofer inductance is no longer needed. Any thoughts?
"Our head is round in order to allow our thoughts to change direction." Francis Picabia
Edits: 10/12/15
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Active crossover for ET-LFE8b - neolith 07:18:39 10/12/15 (1)
- RE: Active crossover for ET-LFE8b - Davey 07:39:46 10/12/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
