In Reply to: Magnepan MG-1 Tweeter Rewire issue posted by brucie372@gmail.com on October 11, 2015 at 05:42:32:
Your problem would not be caused by a bad cap or crossover. Most likely the solder connections are faulty. Soldering aluminium can be a real bitch. Try remelting the connections.
"Our head is round in order to allow our thoughts to change direction." Francis Picabia
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Magnepan MG-1 Tweeter Rewire issue - neolith 07:51:34 10/11/15 (7)
- RE: Magnepan MG-1 Tweeter Rewire issue - brucie372@gmail.com 08:06:26 10/11/15 (6)
- RE: Magnepan MG-1 Tweeter Rewire issue - Roger Gustavsson 09:33:47 10/11/15 (5)
- RE: Magnepan MG-1 Tweeter Rewire issue - brucie372@gmail.com 19:32:07 10/17/15 (4)
- RE: Magnepan MG-1 Tweeter Rewire issue - Roger Gustavsson 03:07:06 10/18/15 (3)
- RE: Magnepan MG-1 Tweeter Rewire issue - brucie372@gmail.com 19:07:22 10/13/15 (2)
- RE: Magnepan MG-1 Tweeter Rewire issue - brucie372@gmail.com 08:50:41 10/22/15 (1)
- RE: Magnepan MG-1 Tweeter Rewire issue - j beede 19:26:51 10/22/15 (0)