|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Acoustat 3s Panel Buzz posted by davidbeinct on July 31, 2015 at 04:11:51:
Agree with Dogwan. Most likely a loose stator wire. Even if not a stator wire, worst case is to replace the offending panel. Very easy to do with my Monitor IV's, but kind of a PITA for you due to the way the Model series is put together - you have to mess with the socks. The Monitors have the Velcro'd cover on the back which pops right off and gives easy access to the panels. Don't worry about opening them up too much. Once you get to see what's inside you might be surprised to see how simply put together they are. It's nowhere near brain surgery. Replacing a panel is no big deal if you have to got that route. The only trick to installing a replacement panel is to be sure to connect the wires from the front and back stators in the proper phase with the other two panels. You don't want the other two panels to be pushing and the replacement to be pulling ... ask me how I know.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Acoustat 3s Panel Buzz - Sondek 12:14:40 07/31/15 (3)
- So, Mike, how do you know? :-) - Cory M. 15:46:41 08/02/15 (2)
- RE: So, Mike, how do you know? :-) - Sondek 19:08:30 08/04/15 (0)
- RE: So, Mike, how do you know? :-) - Sondek 11:26:59 08/04/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
