In Reply to: RE: How t measure the impedance of Ribbon tweeters? posted by Norman M on March 23, 2015 at 16:35:23:
When measuring this low it is rather difficult to get real measurements. One thing you mention is the addition of a series resistor in line with the new ribbon. Do the math. A two ohm ribbon is going to have a lower voltage drop than a 3 ohm. The resistor is absorbing roughly one third of the signal that the previous 3 ohm ribbon received. You might try playing around with this resistor in value first. Lowering it should raise your tweeter output.
Cheers
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How t measure the impedance of Ribbon tweeters? - jazzbeat 02:54:16 03/25/15 (0)