In Reply to: RE: "adding cone woofers for use under 40Hz with my modded MMGs." ... posted by andyr on March 16, 2015 at 18:42:55:
I'm not sure I understand, "If you delay the woofers ... you have to delay the mids & ribbons by the same amount".
DSP gets you both phase and impulse alignment typically by delaying the mains, never the subs. That's to offset the time lag from the low pass (subwoofer) filter. An 80Hz 2nd order crossover frequency has an inherent group delay of about 3.125ms equivalent to 3.5ft.
You could have a speaker setup where the subs are several feet closer to the listening position than the mains which would more than offset the LP delay, but that's a pretty unusual case.
I'm looking forward to your experiments!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: "adding cone woofers for use under 40Hz with my modded MMGs." ... - Barry 22:00:05 03/16/15 (12)
- Sorry, Barry - I didn't make myself as clear as I should've ... - andyr 01:45:36 03/17/15 (11)
- This should save you some time & give you something else to do - Barry 15:40:12 03/17/15 (10)
- RE: This should save you some time & give you something else to do - Satie 20:43:04 03/17/15 (8)
- For the uninitated like me - Barry 18:13:34 03/18/15 (7)
- RE: For the uninitated like me - Satie 06:55:02 03/20/15 (0)
- RE: For the uninitated like me - Roger Gustavsson 00:24:04 03/19/15 (5)
- RE: For the uninitated like me, no microphone - A.Wayne 12:32:02 03/27/15 (4)
- RE: For the uninitated like me, no microphone - JLindborg 14:50:23 03/27/15 (3)
- RE: For the uninitated like me, no microphone - Roger Gustavsson 07:56:11 03/28/15 (2)
- RE: For the uninitated like me, no microphone - A.Wayne 16:53:56 03/28/15 (0)
- RE: For the uninitated like me, no microphone - JLindborg 08:19:39 03/28/15 (0)
- Thanks for the links, Barry ... - andyr 16:18:15 03/17/15 (0)