|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Wood Frames for MGIIIa and general consensus on mods posted by Voncarlos on February 27, 2015 at 07:04:00:
There IS NO consensus on panel mods / reframe.
The Magnestand I've heard were GOOD with real wood. Others swear by metal reinforcement or a simple addition of 'Mye' stands. Part of the Magnestand changes involve crossover mods, so THAT's another factor to consider.
Some guys go after the pole piece with damping or even isolate the driver FROM the frame with some kind of vibration absorbent material.
Some will couple / spike to the floor. I've seen GRANITE used in stands. Other mods involve an element of isolation or CLD between panel/frame and the floor (CLD=Constrained Layer Damping)
So, if you want wood, Build 'em and they will come. Want bridgework? Break out the welding goggles. Corian? Aluminum? Plyboo?
Lots of discussion, some slightly heated, but little actual 'agreement'. The important thing is to HAVE FUN.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Wood Frames for MGIIIa and general consensus on mods - pictureguy 18:51:47 02/27/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
